After mucking about for the last three weeks trying to get sheeting lengths and jib/main angles correct for a new boat, it makes me think that perhaps it would be easier to use flat rectangular spars
for the jib and main booms. Easier to drill multiple holes through a flat carbon spar than trying to figure out a simple way to secure on a 6mm round, and make it adjustable.
Any thoughts? I have done allot of internet research on this subject, trying to find the most easy, simple way to make adjustments quickly,not many answers, What do you do?
I have seen the rubber o-rings and wound wire thingies, but wonder if there is another lighter way to do it.
Kurt